I'm trying to find random things I can accomplish while I'm waiting for my back ordered primer. I installed the Dynon pitch servo bracket on the elevator bellcrank rib. Ignore the lovely primer scribbles on the vertical rib - I had to cover up a bunch of scratches to the Rustoleum primer where I looked at it funny. Hence the reason I'm not a huge fan of the spray can primer.
The roll servo gets installed in the right wing. Most of the original brackets say in place, but Dynon adds in a few pieces to accommodate the servo. Here's the original setup:
I replaced the bottom bracket, as well as added a diagonal rear bracket arm (hard to see in the picture, but it's by the arrow) that will support the servo itself. To allow the servo to connect to the bellcrank, a spacer and plate is added to the bellcrank. This will eventually get a pushrod that connects the two. For now, this is all that I'll put together though. I'll buy the servos when I'm ready to start doing a lot of the wiring in the plane.
