I finally get to start doing some riveting again! There are a few items that pay to rivet together first before putting the skins on. I put the nutplates on the 684 gussets and then riveted the gussets to the vertical firewall angles.
Next up were the gear attach webs and the 902 bulkheads. The bulkheads also have a couple of nutplates that will be used for attaching clamps for the fuel vent lines.
The right and left stiffeners were riveted to the angle clip and then riveted to the firewall angles.
Space is getting tough to come by with parts all over the place and the firewall, center section, side skins, tailcone, etc. all spread out. I started deburring holes in the tailcone (where it attaches to the center section) and then got the left side skin holes deburred. It's now ready for dimpling.
