The 4 seat belt anchors (8 pieces) bolt to the front of the 705 bulkhead. For some reason Van's chose not to drill the bolt holes in them, so that's my small task for today. The idea is to drill one anchor of each pair, then use that to get the second one lined up for drilling. I marked out the hole locations on all of the left side anchors and drilled the first set of holes.
After one side of each pair was done, they were temporarily bolted to the bulkhead and a 3/16" shim was put in place to locate the other anchor. These holes were drilled using the bulkhead holes as guides.
Four of the anchors had to be trimmed by varying amounts to allow the seat ribs to clear them.
